The production line of charcoal machine equipment consists of four parts: crusher, dryer, rod making machine and carbonization furnace. The initial installation steps of the charcoal machine production line equipment: The procedure for preparing and operating the money in the charcoal machine equipment is to debug the main machine, first manually rotate the main machine to see if the smoothness is appropriate, and then use the large and small gears to see if Normal; through the installation diagram of the circuit diagram, install the correct circuit, start the drive motor to see if it is formed; secondly, open the arterial dust collector, check the normality of the air pump pressure, whether there is air leakage, dust removal; again need to open the burner, according to the temperature To debug the appropriate flames and control the temperature; finally, adjust the speed of the dryer to the appropriate range of materials; complete set of facilities for charcoal equipment requires crusher, dryer, bar machine and carbonization furnace The whole operation first pulverizes the material, then the drying mechanism rod finally enters the carbonization process, and the moisture of the material is controlled between 6% and 12%, and the standard setting of the dryer needs to control the temperature of the outlet at 60 degrees. Drying 35% of the moisture-containing material to 6%, the customer can adjust the temperature to the drying degree according to their own needs. The set temperature of the mouth is constant, and the moisture content of the raw material should not exceed 35%. This is the process flow of the entire set of equipment for the charcoal machine.
Want to know about our machine, you can send the question to E-mail: allenshuliyguo@gmail.com
No comments:
Post a Comment