Since the charcoal making machine equipment is an energy-saving and environmentally-friendly production equipment, the machine can use biomass waste as a raw material to produce new types of charcoal that people need very much, but many users do not know much about charcoal making machine equipment. The overall basic structure of the equipment, which will cause failure in the later production, or when the purchase is not suitable for the appropriate equipment, resulting in some losses in the later period.
The charcoal making machine equipment fills in the raw materials of the biomass fiber which can produce charcoal, such as branches, straw, straw, peanut shell, tree trunk, cotton straw, tea seed shell, husk, weed, leaf, etc. The powder into 10mm is dried by the dryer to make the water content within 12%. Then the raw material is put into the sawdust briquetting machine and then formed into a carbonization furnace after high temperature and high-pressure molding (without adding any additives). Carbonization, finished charcoal. It is also possible to carbonize the material powder directly into a carbon powder using a continuous carbonization furnace at a high temperature.
The basic structure of the charcoal making machine is as follows:
1. Main body: The fuselage is an independent rectangular cylinder. The upper bearing block is connected with the powder bucket. The powder bucket extends to the outside of the machine. The V-shaped chassis is installed underneath. The ground is wide and flat, so it must be installed. It can be placed indoors at will.
2. Granule manufacturing device: the rotating roller is placed horizontally under the powder bucket, and there are bearing supports on the front and rear. It is driven by the rack to make the reverse rotation. The front bearing cap of the end face is movable. The next wingnut, the bearing cap, and the rotating drum can be extracted. The two ends of the roller are formed with a convex square ring embedded in the bearing chamber so that the oil does not penetrate into the powder and is not stuck.
3. Reducer: It adopts worm gear transmission, the speed ratio is 1:12. The oil can be stored in the box to ensure good gear lubrication and no noise. The mirror can be observed on the box, observe the operation and oil storage, and the outer end of the worm wheel. Equipped with an eccentric shaft to drive the rack to reciprocate.
The above is the introduction of the basic structure of the charcoal making machine equipment. Through these users, we have more understanding of the charcoal making machine equipment and understand the production of charcoal making machine equipment so that we can better operate the charcoal making machine equipment to produce charcoal. To ensure the quality of charcoal produced is better.
Please pay attention to our website for more details:
https://www.charcoal-machines.com/charcoal-making-machine-for-sale.html
No comments:
Post a Comment