We must pay attention to safe production during the production process of Charcoal or Coal briquette machine. Let's talk to our customers and friends in detail:
1. Check the lubrication of the equipment and the tightness of the V-belt before starting the machine.
2. Adjust the amount of coal and the moisture of the material according to the index of the ammeter. Ensure that the moisture content of the material is controlled at 12%-14% to ensure the forming strength of the coal rod.
3. When Charcoal or Coal briquette machine is working, the operator should control the amount of coal to be fed to avoid material breakage or overfeed. It is strictly forbidden to stand at 10m in front of the head of the molding machine to avoid spraying and injuring people.
4. It is forbidden to use materials such as iron rods and high hardness tools in Charcoal or Coal briquette machine to avoid being damaged by Charcoal or Coal briquette machine. When the stick is stirred in, immediately let go, so as not to hurt people, and stop cleaning.
5. When the head hole is blocked, it should be cleared at any time.
6. Charcoal or Coal briquette machine should empty the material when it is out of service for more than 2 hours. And add a small amount of water when you re-drive.
7. Before installing the machine head, clean the coal on both ends of the machine head and the discharge shell assembly, and then install the clamping device.
8. If the startup is unsuccessful twice during the start of the drive, the start should be stopped. To find out the cause, drive again after troubleshooting. It is these eight procedures that help the safe production of the Charcoal or Coal briquette machine.
No comments:
Post a Comment