Details in the charcoal making machine assembly line

With the development of the charcoal making machine industry, large-scale charcoal making machine equipment has become the main equipment for the production of charcoal. In the usual production process, there are often some details that are easily overlooked, which have not caused the attention of the relevant personnel, not only affecting the normal production work but also causing more serious production accidents or economic losses after a long time, then the large charcoal making machine What are the details that are easily overlooked in the assembly line?

First, we must pay attention to electricity. In the production process of charcoal making machine, the safety hole that is easily overlooked is electricity. The rod forming equipment of charcoal making machine uses an electric motor, which uses 380V electric power, and the body is made of steel material with good heat dissipation performance, but At the same time, it is also electrically conductive. Many operators do not notice this when a fault occurs and accidentally touch an electric shock event.

The solution to this type of security vulnerability is to install a leak protection device at the power supply or install an air protection switch at the bus to avoid accidental electric shock. Secondly, a grounding device should be installed on the motor body to avoid leakage.

Second: pay attention to fire prevention. The charcoal making machine is easily overlooked in the production of safety holes and fires. The carbonization furnace is formed by carbonizing the formed carbon rods through high-temperature combustion. Generally, the central hole portion will have Mars. It is necessary to pour Mars out to be completely cooled before carrying out the stacking. Do not accumulate indoors, which may cause fire.

Third, reasonable temperature control. The production activity of the charcoal production line is inseparable from high temperature. When the mechanism carbon is molded, it needs to be extruded under high temperature and high-pressure environment. It is completed by the heating coil of the charcoal production line and is heated by the heating coil. Heating to 260-350 degrees Celsius can ensure that the fabricated carbon rods reach the required density. The point to note is that the charcoal production line should be preheated and then discharged for production and processing.

 Fourth, proficient in the living process and raw material moisture. The mechanism of charcoal produced depends on the equipment and process, and depends on the size of the water contained in the raw materials. Generally, the moisture content of the raw material is less than 12%, but it is also greater than 6%, so as to greatly avoid the resulting salary bar being easily broken due to excessive moisture content. These are just some of the details in the process of making rods in the production line of charcoal making machines. They are also a key part. The good and bad of the rods also affect the effect of carbonization in the future. Therefore, in each production process, we must judge according to the production experience. And adjustments.