Potato slicer safe use instructions

With the development of society, the potato slicer gradually entered our lives, but for this large kitchen equipment, we still don't know much about it. How to run the potato slicer, about the accident caused by improper use of the potato slicer? Abound, below, Zhengying Machinery will introduce you to the safe use instructions of the potato slicer, I hope to help everyone.

1. Try cutting before work, and observe whether the specifications of the cut vegetables are the same as the required specifications. Otherwise, the slice thickness or the length of the cut vegetables should be adjusted, and the normal work should be carried out after meeting the requirements.

2, potato slicer installation vertical knife

1 Intelligent potato slicer installation vertical knife: put the vertical knife on the fixed knife plate, the cutting edge is in parallel contact with the lower end of the fixed knife plate, the fixed knife plate pin is on the knife holder, the cutter nut is fastened, and the fixed knife plate can be removed. .
2Other potato slicer installation vertical knife: first turn the adjustable eccentric wheel to make the knife holder go to the bottom dead center, then lift the knife holder up 1/2 mm, so that the vertical knife contacts the conveyor belt, tighten the nut Fasten the vertical knife to the knife holder.

Note: The height of the elevated lift can be mastered according to the vegetables being cut. If the elevated height of the overhead is small, the vegetables may have a knife. If the elevated height of the overhead is too large, the conveyor belt may be cut.

3. Length adjustment of cut vegetables: Observe whether the length displayed on the control panel matches the required length. Press the increase button when increasing the length and the decrease button when reducing the length. Other potato slicer adjustment: turn the adjustable eccentric wheel, loosen the connecting rod fastening screw, the potato slicer cuts the filament to move the fulcrum, from the outside to the inside; when cutting the thick wire, the fulcrum can be moved, from the inside to the outside, after adjusting Tighten the adjusting screw.