The first step of equipment installation of the new charcoal machine production line: Before starting the new charcoal machine, preparation work and operation procedures are required. When debugging the host machine for device verification, first let the host machine rotate manually to see if it is stable, and then use the size and gear of the device to check whether the operation is normal; install the correct circuit through the installation diagram of the circuit diagram and start.
Motor, to see if it is running normally; secondly, turn on the dust removal equipment, check the normal pressure of the air pump, whether there is leakage, dust removal; again, you need to turn on the burner, adjust the appropriate flame according to the temperature, temperature control strategy; adjust the speed of the dryer To a suitable range.
The new charcoal machine is a complete set of equipment, including pulverizer, dryer, rod making machine and carbonization furnace. In the whole operation process, the materials are crushed first, and then dried by the dryer, and the rod making mechanism enters the carbonization process. The moisture content of the material is controlled between 6% and 12%, and the standard-setting of the dryer requires the outlet temperature to be controlled at 60 degrees and the moisture content to be controlled between 35% to 6%. The operator can also adjust the drying temperature according to his needs, set the outlet temperature unchanged, and the moisture content of the raw material does not exceed 35%.
The above is the method of correct installation and configuration of the new charcoal machine. Users can install and configure according to these, to ensure that the new charcoal machine has a better production mechanism for charcoal, improve its production efficiency and quality, and bring better benefits for itself.
No comments:
Post a Comment