How does the charcoal making machine work?

Charcoal is the use of resources such as agriculture, forestry, industrial waste, and waste. And gradually form a new energy system. Charcoal is easy to store, no loss, no smoke, no pollution, and is widely used in industry, food, pharmaceutical and life. Runhe Machinery helps you achieve great achievements.
      According to the raw materials, the charcoal machine can be divided into a straw charcoal machine, a sawdust charcoal machine, a rice husk charcoal machine, a branch charcoal machine, a shaving charcoal machine and the like. The charcoal machine is mainly composed of a pulverizer, a dryer, a rod making machine, a carbonization furnace and four equipments.

The production of charcoal can be divided into four steps.

      1. Crushing The raw materials are pulverized into granules by a pulverizer.

      2. Drying Then dry the granules through the dryer and avoid the moisture.

      3. Rods The dried materials are rod-shaped through a bar machine.

      4, finally through the carbonization of the carbonization furnace, after cooling is the finished charcoal machine

      The above process is a simple process of the charcoal machine from raw materials to finished products. Now the technicians are sorting out some of the decisive factors that we have sorted out according to the status of the ready-made situation. I hope that our little sweat can achieve your success.

      1. When the stick is out, it is not good, the time is good or bad: the main reason may be that the heating power is not enough, the temperature of the raw material is not uniform, the amount is best after drying, and the drying temperature is uniform, so that the automatic feeding system is best.

      2. There are many cracks: the density is small: the pressure is small by adjusting the screw; the forming sleeve is more difficult to solve; the temperature is high, the temperature is adjusted; the principle is small lignin, and the material is mixed with lignin;

      3. Shooting: The material is wet, and it has to be re-baked. If it is dead eye, it is necessary to correct the positive axis of the screw tip and smooth the taper part;

      4. No returning gas: adjust the screw compression ratio.

      Different compression ratios are required for different materials. This is because many screws don't know what the problem is. The shaft is also positive and not worn. The first day is good, but the next day will not work. The root cause can't be done. The fineness and softness of the material have different requirements for the screw. In general, the compression ratio of the mixed wood is small, and the compression ratio of the fir is large. This is why many people say that the sawdust of the fir is not worth the money. This requires the production staff to judge based on experience and materials, preferably a factory. It is necessary to have a screw for a variety of materials, and the materials should be roughly separated.

      Charcoal has become a very good industry today, and organic charcoal technology is more important. Only when charcoal technology reaches its peak, can we create a better business.